INSTRUCTIONS FOR THE CONSTRUCTION OF THE COMPOSING FRAME

• The aluminium constructor should have good knowledge of both the product range of the profiles as well as their attributes

• To provide solutions and recommend the right constructions given the needs and requirements of the client

• To construct and install the correct "fake-frame" according to the type of the composing frame

• Space must always be left between the "fake-frame" and the casing of approximately 2.5-3mm to each side (considering the under base insulation gasket), for easier placement and alignment of the casement and for best insulation

• The constructor must cut and pierce the profile properly and treat all the jointing points of with anticorrosive materials.

• The constructor must put silicone at the jointing points in order to guarantee a waterproof assembly process

• During placement, the constructor must put silicone at the bottom side between the "fake-frame" and the marble, so as to prevent water leaks

• All the necessary water drainage must be constructed according to the position of the casing

• Openings must be created so as to flush out the sediments from the bottom side of every shutter sash, thus providing protection from corrosion.

• The constructor must always use the proper accessories, as shown in the catalogues of EUROPA ALUMINIUM S.A.

• Close attention must be paid on gaskets, using exclusively those made of E.P.D.M.

• All panes must be fitted properly, thus providing an affective and stable structure.

• No constructor should hesitate to ask for assistance from our specialized team of technical advisors at any time.

Note: Gaskets should be replaced after a certain period of time. When the aforementioned replacement is undertaken, the instructions provided by EUROPA ALUMINIUM S.A. for this process must be followed.